Wintriss SmartPAC2, User Manual

Page: 256 / 383

SmartPAC 2 User Manual 1126700
Preventive Maintenance Monitor A-11
7.
Next, the number display appears superimposed over the previous display (see the next
illustration). Use the number keys or cursor keys to set the tracking frequency for the PM
item.
8.
In the following illustration, we entered the slide adjust motor as our first PM item, set the
tracking unit of measure to be “die changes”, and the frequency at “100”. Notice that the
PM name is listed just below “new item”.:
9.
To set more PM items, repeat steps 1 through 8. When you are completely done
initializing the PM items, press RESET to return to the Main Initialization Menu.
10.
You can now go to the Run mode to view the PM Monitor status conditions. There is no
PM information to set in SmartPAC’s Program mode. You made all the required settings
in the Initialization mode.
Figure A-11. Superimposed Number Display
Figure A-12. Programmed PM Item: Example
ENTER A MAINTENANCE FREQUENCY FOR
AIR ROTARY SEALS
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSOR KEYS TO
INCREMENT/DECREMENT. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
to set frequency/tracking
units for monitored item,
use number keys (up
to 7-digit number), then
press Enter.
YOUR PRESS NAME PM MONITOR
0
ITEM ALERT EVERY
USE THE CURSOR KEYS TO MAKE
SELECTION. PRESS ENTER TO SELECT
RESET WHEN DONE.
NEW ITEM
100 DIE CHANGES
in this example, we
entered "slide
adj. motor" and
set it to alert at
100 die changes
YOUR PRESS NAME
PM MONITOR
SLIDE ADJ. MOTOR