Wintriss SmartPAC2, User Manual

Page: 158 / 383

SmartPAC 2 User Manual 1126700
Program Mode 5-15
2.
Select the value displayed for the item you want to program (i.e., PARTS MADE PER
EACH STROKE or STROKES TO MAKE EACH PART). The Numeric Entry window
(see Figure 5-3, page 5-3) displays.
3.
Key in the value you want, following the directions in the window, and press ENTER.
The value you keyed in displays in the field you selected in step 2.
4.
Press RESET to return to the Counter Mode Selections screen.
Setting Batch Pre-Load Counts
If you are setting up a tool for gagging operations, you can specify a pre-load count for each
Batch counter on the Advanced Counter Mode Selections screen. This pre-load value
displays in the COUNT field for each Batch counter you specify, decreasing by that value the
number of strokes (or good parts) required to reach the preset value. You can reset these pre-
load values in Run mode when the Batch preset is reached (see COUNTERS, page 6-7) as
long as you set the CHANGE COUNTS parameter on the Security Access Menu in
Initialization to PROGRAM AND RUN MODES (see SECURITY ACCESS, page 4-24).
To set batch pre-load counts, do the following:
1.
Select the pre-load count value for the batch you want (e.g., Batch 1, Batch 2, etc.). The
Numeric Entry window (see Figure 5-3, page 5-3) displays.
2.
Key in a pre-load count value, following the directions in the window, and press ENTER.
The value you keyed in displays on the Advanced Counter Mode Selections screen.
3.
Make sure that the AUTO BATCH PRE-LOAD field is set to OFF.
4.
Press RESET to return to the Counter Mode Selections screen.
Figure 5-15. Advanced Counter Mode Selections Screen