Wintriss SmartPAC2, User Manual

Page: 215 / 383

1126700 SmartPAC 2 User Manual
6-18 Run Mode
Cam channels are displayed by number on the Y-axis. Only eight channels can be displayed
at a time, so if a 16-channel ProCamPAC is installed, you must press ENTER to display
channels 9 through 16. The X-axis displays the number of degrees of crankshaft rotation
(from 0
°
to 360
°
) at which channels turn on and off.
Channel On/Off and Auto Advance timing is shown as a colored horizontal bar, the end points
of which, when read against the crank angle “ruler” on the X-axis, specify on and off settings
for that channel. The bar for On/Off channels is blue, the bar for Auto Advance channels
green with the letter “A” at each end. When the dwell for an Auto Advance channel is very
short, the terminal “A”s may display with no bar between them, as shown for Channel 2 in
Figure 6-19. As press speed increases, the bar for Auto Advance channels moves to the left.
Channels with Timed outputs are shown in pink characters beginning with the letter “T,” the
position of which, when viewed against the crank angle “ruler,” indicates the On angle,
followed by a number (e.g., 250), which indicates the channel’s On time in milliseconds.
The Cam Timing screen is updated once every second.
Viewing the Global Cam Summary
(RUN – CAM SWITCH – F5-VIEW GLOBAL CAM SUMMARY)
You can view a summary of the Global cams by pressing F5 (View Global Cam Summary).
The screen that displays is identical to the Global Cam Summary screen accessible in Program
mode (see Viewing Global Cams, page 5-47) except that it displays additional information in
the Status box.
Figure 6-19. Cam Timing Screen
Channel 4:
Timed output
(pink)
Channel 3:
Auto Advance
timing (green)
Channel 7:
ON/OFF timing
(dark blue)