11
Diagnosis / monitoring in the control unit and fault elimination
LED on the
circuit board
LED
colour
Function is
OK
Malfunction
Diagnose
Netz
(= mains)
green
Lit
Off
Check mains voltage and mains
fuse (F1)
Betrieb
(= operation)
green
Lit
Off
Check all functions in the
board, main fuse F1
Akku
(= battery / load
control)
yellow
Off
Flashes when main
failure or when
charging voltage is
under 26V.
Lits when
battery no connection,
battery fuse defect,
Battery voltage under
19V
Check main fuse and charging
voltage.
Check battery connection.
Check battery fuse (F3)
Check battery voltage
Motor
(actuator circuit)
yellow
Off
Flashes when
interrupted
Check actuator fuse (F2) and
actuator end module
RWA-Taster
(= break glass unit)
yellow
Off
Flashes when
interrupted. Lits when
short circuit.
Check wiring and jumper J1 in
the last or only break glass unit.
Rauchmelder
(= smoke detector)
yellow
Off
Flashes when
interrupted. Lits when
short circuit
Check wiring and the active end
module.
Battery and actuator circuit malfunction be about 8 sec. delayed.
Operation / LED diagnose
Alarm (= alarm)
red
Lits when activated
Wind/Regen (= wind / rain)
green
Lits when activated
5. Installation
The smoke control panel has to be installed in a dry room.
5.1. Surface mounting
WSC 204 / WSC 204KP / WSC 204BZ
Mount the included frame on the smoke control panel and fix the panel to the wall through the four mounting
holes on the back plate of the panel.
WSC 204MH
Open the smoke control panel and mount through the 4 holes on the back plate.
The wall must be suitable for the purpose.
Notice! Add gaskets on the screws between the panel and the wall to achieve the protection class IP54.
