Using the WebGUI interface of the POS Device HUB
52
BEETLE /moPOS "Getting Started"
attempt has been failed again (measured in seconds). So the total network timeout is calcu-
lated by:
<total timeout>
=
<keep alive timeout>
+
<number of probes>
X
<interval>
.
In case all probes of reconnecting have been failed after the total network timeout the lower
level network driver stack messages an error to upper layer software and a disconnect situa-
tion has been occurred.
In case one reconnect attempt has been succeeded the connection is reestablished again
and the firmware of the POS Device HUB continuous working without an error.
Usually the network connection timeout have a good presetting and do not need to be ad-
justed.
When doing all changes you have to confirm your changes, the button “change settings”
needs to be clicked and the system must be rebooted.