WINCODE LP4 Series, User Manual

Page: 38 / 72

LP4 USER MANUAL
- 38 -

Get Label Size: The detecting value of label size will be showed in the
right table

Get sensor value: The detecting value of sensors will be showed in the
right table

Cutter Turning Clockwise
：
Cutter cuts label from up to down (Fully cut)

Cutter Turning Anti-Clockwise
：
Cutter cuts from down to up (Not
completely cut-off)

Restore Factory Defaults: The parameters of printer will be factory
default setting.

Printer Self Test: Printer will print the inside settings on the label

Reset Printer
：
Restart the printer

Enter DUMP Mode: Entering to the DUMP mode, so printer will printer
the ASCII code of objects on the label
Settings Please refer to the 8.7 Settings
File
Management
Send the selected file from stored spaces to the printer (Ram Disk, Flash Dish,
and SD Card) and also can manage these files in these spaces.
Send
command
Send printer’s command to printer, please refer to the Printer Command
Manual.
Unit- Tools
page
Printing unit: millimeter (mm), centimeter (cm), inch (in.)