setup
. For further information, check the instructions that came with your new software.
WARNING:
Although a lot of software floppy disks came with your WinBook FX, most of this
software is already installed for you. DO NOT install more software until you see what is already
on your system.[FX 1-10]
Swapping the CD-ROM and Floppy Drives
The WinBook FX will arrive with the CD-ROM Drive installed in the Media Bay. To use floppy
disks, you must remove the CD-ROM Drive and install the Floppy Disk Drive module. You can
swap modules under the following conditions: The WinBook FX is OFF, not charging the
battery, and unplugged, or is OFF and charging the battery.
Swapping Modules in the Media Bay
Make sure the power is OFF.
Place the WinBook FX on a flat surface, top down.
Locate the Media Bay release catch. Slide the release catch as shown in the illustration, and
pull the module out of the bay.
Align the replacement module and slide it in gently until the release catch snaps into place.
Be sure to push the module all the way in so it is securely seated and flush with the edge of
the computer.
[FX 1-11]
FX Chapter 2
Summary of Contents for FX
Page 26: ...FX Chapter 3 ...
Page 123: ......