9
10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Powering up a Wilson Electronics
Signal Booster
1 . Never point the front of a directional Outside Antenna toward the Inside
Antenna . Refer to Figures above .
2 . Ensure that both the Outside Antenna cable and the Inside Antenna
cable are connected to the Signal Booster
and the connections are
tight
before powering up the Signal Booster .
3 . Plug the power supply into the Signal Booster input marked “6V DC”
(carefully, to avoid damaging the center pin) and then into a surge
protected AC Power Strip .
4 . If the Signal Booster does not have a green light, please refer to pages
10-14 .
5 . Using multiple Signal Boosters in one installation could cause
interference to the cell tower .
6 . Contact Wilson Electronics Technical Support Team with any questions at
866-294-1660 or email tech@wilsonelectronics .com . Technical Support
hours are Mon .- Fri . 7 am to 6 pm MST .
Channel Select Directions for 800 & 1900 MHz
Note:
For a list of channel options see tables on page 15.
If you know your desired channel setting, press or hold down the
1 .
yellow CH Select button until that channel UL center frequency and
bandwidth are displayed on the LCD screen . Refer to pages 11 &
12 for further instructions about the LCD screen display numbers .
Refer to page 15 for Uplink and Downlink Channel Selection Chart .
Signal Booster
Outdoor
Antenna
Inside Panel
Antenna
Figure 1
Figure 2
CORRECT INSTALLATION
Point antennas away from each other
INCORRECT INSTALLATION
Never point antennas toward each other
Inside Panel
Antenna
Signal Booster