7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
8
Cell Tower
Drip hole on bottom
Installing Lightning Protection
(sold separately)
Outside Antenna Installation
The antenna should be mounted as shown in the illustration above .
The mounting bracket, included with antenna, is adjustable and will
accommodate pipe diameters from 1 .25” to 2” (pipe sold separately
#901117) . Mount the antenna so that there is at least 3 feet of clearance
in all directions around it . Position the antenna so that it has an
unobstructed line of sight to the cell tower’s strongest signal . Make sure
the antenna is not pointing across your own roof or at the Inside Antenna
as this will cause the oscillation protection circuitry to shut down the
Signal Booster .
Warning:
Lightning protection is recommended for all installations
(#859902-50 Ohm shown below) . Take extreme care to ensure
that neither you nor the antenna comes near any electric power line
Install the Lightning Surge Protector
(LSP) close to the Signal Booster .
Attach the cable from the Outside
Antenna to the surge protector, using
a short length of low loss cable; attach
one end to the LSP and the other to
the Outside Antenna connector on
the Signal Booster . Ensure the LSP
is properly grounded (ground wire not
included) . LSP sold separately, at
www.WilsonElectronics.com
or contact
our sales team at 800-204-4104 .
(not included)
Lightning
Surge Protector
(sold separately)
Signal Booster
Surge Protector Power Strip
Ground Wire
(not included)
To Outside
Antenna
To Signal Booster
To Inside
Antenna