11
12
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
During installation mode the Signal Booster is resetting itself very quickly
to aid the installer . The Signal Booster is equipped with one indicator light .
For the first 15 minutes that the booster is plugged in, it is programed for
a test and alignment period . During this time, the light and the LCD will do
one of the following 5 things:
Understanding the Signal Booster Light,
LCD Screen and Troubleshooting
Note:
If after the initial 15 minutes you are not done with the
installation, the Signal Booster can be reset and enter installation
mode again by disconnecting and reconnecting the power supply
from the Signal Booster.
CH
Select
UL CH DL
70 A 72
800 MHz Channel
Max
Min
UL
Gain
Max
Min
DL
Gain
The corresponding DL frequency
automatically adjusts and is
always 80 MHz higher than
the UL frequency shown . For
common settings please refer to
the chart on page 15 .
The Uplink (UL)/Downlink (DL)
4 .
gain is displayed on LCD screen
above the knobs . Uplink is on the
left and downlink is on the right .
Turn appropriate knob to adjust .
The Uplink (UL) knob limits only
5 .
the uplink gain, whereas the
Downlink (DL) knob limits both
the uplink and the downlink gain .
You will typically adjust only the downlink knob .
6 .
If the Signal Booster is operating normally the LCD screen will
7 .
appear similar to Figure 4 . If it does not appear similar to Figure 4
refer to Troubleshooting section below .
CH
Select
1880.0
70 15 72
1900 MHz Channelized
Max
Min
UL
Gain
Max
Min
DL
Gain
1900
MHz
UL Center Frequency (MHz)
Uplink
Gain (dB)
Bandwidth
(MHz)
Downlink
Gain (dB)
1. BLINkING GREEN
If the Signal Booster is
blinking green, the Signal
Booster is operating
properly . If you are happy
with the coverage area in your building, then you are done .
Blinking will stop after the 15 minute installation period .
Figure 4
green
