9
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
10
In some cases, multiple Inside Antennas may be required, for instance if
you have multiple rooms with poor signal . A signal may be split by using
a splitter (sold separately) . If using more than one Inside Antenna, a
separation up to
75
horizontal
feet
may be necessary between Inside
Antennas . Refer to configuration on pages 3 & 4 .
Installing a Wilson Electronics Signal Booster
Select a location to install the Signal Booster that is away from excessive
heat, direct sunlight, moisture and that has proper ventilation . Do not
place the Signal Booster in an air-tight enclosure . Recommended
installation locations for in-building Signal Boosters are near a power
outlet and in a closet or on a shelf .
Note:
It is important to have adequate air ventilation. Maintain at least 6
inches of clearance from surrounding objects. Be careful when
plugging the connector in so as not to damage the center pins on
the connectors.
Run the Outside Antenna cable to the Signal Booster and attach it to
the connector labeled “Outside Antenna” on the Signal Booster . Run the
Inside Antenna cable to the Signal Booster and attach it to the connector
labeled “Inside Antenna” on the Signal Booster .
Note:
For distances of 20 feet or more, use Wilson low loss cable.
Note:
It is very important to power your Signal Booster using a surge
protected AC Power Strip with at least a
1000 Joule rating.
Failure to
do this will void your warranty in the event of a power surge or lightning
strike.
Optional Wide
Band Inside
Antenna (sold
separately
)
Splitter Options:
3-way
(859980)
4-way
(859981)
2-way
(859957)
