en
Switchgear of diesel pump
52
WILO SE 2020-12
ƒ
Press
to activate the selected function.
ƒ
If some functions are not available, the corresponding icon will be disabled, i.e. dis-
played in light grey.
10.1.5
Access via password
ƒ
The password is used to enable or block access to the setup menu and the command
menu.
ƒ
If the passwords have been enabled, you must first enter the relevant numerical ac-
cess code to gain access.
ƒ
To enable the use of passwords and define the access codes, refer to the relevant
setting menu.
ƒ
There are two levels of access, depending on the code entered:
–
User level access - allows you to reset the registered values and modify some
settings of the device.
–
Advanced level access - same rights as the user with the possibility to modify all
settings.
ƒ
From the main screen, press to call up the main menu, then select the password icon
and press it.
ƒ
The password setting window will appear in the figure:
Fig. 11.5
ƒ
Use the
and
keys to change the value of the selected digit.
ƒ
Use the
and
keys to move between digits.
ƒ
Enter all the digits of the password, then move to the key icon.
ƒ
When the password entered corresponds to the User Level Password or Advanced
Level Password, the corresponding unlock message appears.
ƒ
Once the password is unlocked, access will remain enabled until you unlock it:
–
the device is switched off.
–
the device is reset (after exiting the settings menu).
–
more than 2 minutes elapse without the operator touching any keys.
ƒ
Press the key
to leave the password setting and exit.
10.1.6
Scrolling display pages
ƒ
The
and
keys scroll through the measurement display pages one at a
time. The current page is recognisable by the title bar.
ƒ
Some of the measurements may not be displayed depending on the programming
and connection of the unit (e.g. if a fuel level sensor is not set, the relevant page is
not displayed).
ƒ
For some pages there are sub-pages accessible via the button
.
ƒ
The user has the possibility to specify on which page and on which sub-page the
display must return automatically after a time has elapsed without pressing any
keys.
ƒ
It is also possible to program the system so that the display always remains in the
position where it was left.
ƒ
For the setting of these functions, see the relevant menu.
Overview of display pages
Page
Example
Main page
