Kunststoffschweißtechnik
Starting and Operating
Chapter 5
19.09.11
Working Instructions WIDOS 5500 CNC 3.0
Page 40 of 78
press several times button <Start> until shortened cooling time appears
Display:
2. line:
shorted cool. time?
yes
shortened cooling time can be entered
Select “yes” with <+> if shortened cooling time is required.
It is allowed to use the shortened cooling time under the following
conditions:
-
Welding material:
PE
and
PP
-
Prefabrikation under workshop conditions
-
Low additional pressure at unclamp
-
No additional pressure during further cooling down
-
Load onto the workpieces only after being completely cooled down
press several times button <Start> or after a short while appears
automatically:
Display:
2. line:
WIDOS 5500 CNC
22.11.2000 10:10
Basic menu
5.15. Administration of the welding data
The battery-buffered CNC memory (RAM) can store about 400 weldings.
Make sure not to go over this quantity (in the display the error message
"memory full“ appears) because otherwise the first stored welding will be over-
written.
If necessary, copy the welding data on SD-card and read out in time.
5.15.1. Copying internal data onto SD-card and deleting them (RAM)
Abort and back to basic menu by pressing <C>.
One menu item back by pressing <Enter> (keep pressed) and <->.
Display:
2. line:
WIDOS 5500 CNC
09:43 03.05.2007
basic menu
next menu by pressing <Enter> button
Display:
2. line:
copy
_
By pressing <+> the data from the internal memory is transferred to the
SD-card.
