Whirlpool WSE 2930 W, Manual

Page: 81 / 101

Step 1: If the appliance was plugged in for longer than 15 minutes, disconnect it from the
power socket, wait 40 seconds and plug it in again.
Step 2: Wait till the User Interface finish the bootstrap ( only LCD version ).
Step 3: Open the freezer door
Step 4: Press the freezer light switch 3 times within 10 seconds.
Step 5: The test should be activated and on the freezer display you can see the code „00“
For de-activation of the test procedure, disconnect the appliance from the power or repeat
the step 4.
Note: the User Interface will be able to switch ON/OFF the Dispenser Lamp and to drive
the Ice-Motor in Ice-Cube Mode.
Troubleshooting
Activation of the “Built-In” Test Routine
To enter in the test routine, follow the described steps below :