5-3
SURFACE ELEMENTS
LIMITER
2A
2B
1A
1B
2A
2B
1B
1A
Electrical Shock Hazard
Disconnect from electrical supply before ser-
vicing unit.
Failure to do so could result in electrical
shock or other personal injury.
WARNING
Test Procedure
Refer to page 4-8 for the location of the limiters.
To test a limiter, perform the following steps:
1.
Use an ohmmeter and set the range to
R x 1.
2.
With no power applied, touch the ohmme-
ter leads to the following terminals. You
should obtain the following readings:
1A and 2A are closed.
1B and 2B are open.
If the readings are not within the range shown,
the limiter is defective and should be replaced.
MAINTOP SENSING ROD HEATING COIL
INSULATION LIMITER
Electrical Shock Hazard
Disconnect from electrical supply before ser-
vicing unit.
Failure to do so could result in electrical
shock or other personal injury.
WARNING
Test Procedure
Refer to page 4-8 for the location of the sur-
face elements and the procedure for servicing
them.
To test a surface element, perform the follow-
ing steps:
1.
Use an ohmmeter and set the range switch
to R x 1.
2.
With no power applied, disconnect one
wire from the element terminals.
3.
Touch the ohmmeter leads to the element
terminals. You should obtain the following
readings for the indicated element:
Element Location
Resistance
Power
Left Front
22
Ω
±
5
2400
Watts
Left Rear
38
Ω
±
5
1400 Watts
Right Front
32
Ω
±
5
1700 Watts
Right Rear
26
Ω
±
5
2100 Watts
If the resistance reading is not within the range
shown, the element is defective and should be
replaced.
ELEMENT
TERMINALS
LIMITER
TERMINALS
Summary of Contents for 4322525
