Whirlpool 4322525, Manual

Page: 27 / 66

4-7
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before ser-
vicing unit.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the range, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
1. Turn off the electrical power to the range.
2. Remove the control panel and rotate it
back on top of the maintop so it is out of the
way (see page 4-2 for the removal proce-
dure). NOTE: You do not have to remove
the electronic oven control from the panel.
Refer to Figure 4-6 for the following steps.
3. Remove the four chassis screws (two on
each side) from the control panel chassis.
4. Lift the front of the chassis at the center
and prop it up with a board. NOTE: You
may have to unclip the two cooling fan
motor wires to raise the chassis high
enough to access the screws.
5. Remove the four mounting screws from
the ceran glass brackets.
6. Lower the chassis and remove the ceran
glass.
REMOVING THE CERAN GLASS MAINTOP
Control Panel Chassis Screws
CERAN GLASS
MOUNTING SCREWS
CERAN GLASS
MOUNTING SCREWS
Fan Motor
Wires In Clip
Figure 4-6