R
ead
M
e
!
L-8 / Sep 2019
* In previous Navigator GUI versions this was the
System 3rd Party Devices
tab.
Adding The L-8/L-12 To The Peripheral Devices* Tab
NOTE: For the L-8/L-12 control surface software versions after v. 1.4.6
the following procedure is no longer needed and should not be performed.
In order to utilize all the features of the L-8/L-12 control
surface the device must be added to the System
Peripheral
Devices
tab in the Wheatstone WheatNet-IP Navigator program
(aka the Navigator GUI). This sheet shows you the basics of that
procedure. Refer to the
WheatNet‑IP Audio Over IP Network
Technical Manual
for additional details.
You will need to know the IP address of the device being
added, so you will want to find that out before you start.
Launch the Navigator GUI and make sure that
System 0
is
selected in the
System
pane. You will see something like this:
Now select the
Peripheral Devices
tab.
Click the
Add
button to bring up the
Add Peripheral
Device
dialog:
Type in a convenient
Name
and insert the
IP Address
of the device being added. Leave the
TCP Port
at the
default setting of
60021
. From the
Host BLADE
drop
down select the BLADE that you want to associate the
Peripheral device with. Click
Ok
.
This completes the process of adding the device to
the
Peripheral Devices
tab. The added device should
show up in the
System
pane under the BLADE you
added it to. If it does not show up, or if it shows up but
has a yellow question mark on it, then there is either a
network issue that needs attention, or the device is not
connected to the network at all, or one or more steps
have been omitted or done incorrectly in the configuration process.
