page 2 – 12
L-8 / Sep 2013
S U R F A C E C O N F I G U R A T I O N
OL Pre On
– When checked, causes the signal, when assigned to the surface’s
OL output, to be tapped before the channel ON switch.
Mach Start Pulsed
– If this box is not checked, a Machine Start command will
give a steady closure, similar to an On Tally. If your external machine needs to see
a momentary pulse instead, check this box.
Remote Ready
– The channel’s OFF switch normally has its LED indicator
controlled by the switch itself. This is the factory default setting. When
Remote
Ready
is checked, the channel’s OFF switch LED can be controlled by an external
source machine. This requires additional configuration in the optional Navigator
GUI to fully implement the feature.
OL Off Line
– This function determines what will be heard at the fader’s Bus Mi-
nus output when the fader is off. If the box is not checked, when the fader is off the
same bus will feed the bus minus that feeds it when the fader is on, as determined
by the
Bus Minus Base Mix
selection below. But if the
OL Off Line
box is checked,
when the fader is off the Bus Minus output will be fed from the OL bus instead.
Studio Mutes
– Input channels can be programmed to mute the various monitors
when the channel is ON. There are four
Studio Mutes
check boxes, one for each
monitor section plus one for CUE. The checked boxes show which monitors are
muted.
Studio Tallies
– Turning the channel ON can activate a remote tally indicator. There
are four tally control lines. The checked boxes show which tallies are activated. This
requires additional configuration in the optional Navigator GUI to fully implement
the feature.
Also note that the
Studio Tallies
selection will have an impact on the lighting of
the ON AIR indicator in the meterbridge. See the description of
OnAir Tallies
on
the
Engine
tab.
Bus Minus Direct Out
– For each fader, determines if the Bus Minus output is a
mix-minus of the selected Bus Minus Source (unchecked) or is a Direct Output of
the selected input source (checked). On faders where the
Bus Minus Direct Out
box
is checked, the OL Off Line box (above) will have no effect.
Bus Minus Base Mix
– This function determines which bus the Bus Minus output
is a mix-minus of. Any of the four PGM, AUD, AUX, or OL busses can be selected
as the Bus Minus Source. If, for example, PGM is selected, then the Bus Minus
output will consist of the audio on the PGM Bus, minus the signal assigned to the
fader. This is true when the fader is turned on. It also true when the fader is turned
off,
unless
the
OL Off Line
box is checked (above). This setting will have no effect
on any fader where the
Bus Minus Direct Out
box is checked (above).
TIP:
If all your ma-
chines require a
momentary pulse,
just activate
Mach
Start Pulsed
on the
Default.
