page 3 – 7
L-8 / Sep 2013
L - 8 C O N T R O L S A N D F U N C T I O N S
as a balance control in STEREO mode. The PAN slider appears on the top
display. Adjust PAN as desired by rotating the FUNCTION
knob, then press the flashing A/B/SET button again to set it
up. To easily set the PAN to center, you can press the FUNC
‑
TION knob twice in rapid succession, like double‑clicking
a mouse button.
The panning may be denied to a user in the Talent Access
tab of the
Wheatnet IP L8 Setup Tool
GUI.
MODE Button
The channel’s INFO display shows which one of the
four modes (Stereo, Mono, Left only, and Right only) the
channel is in on the center of the bottom line of the display:
STEREO
– Left in feeds fader L, right in feeds fader R. If
a mono source is selected, it will feed both L and R.
MONO
– If a stereo source is selected it is summed to mono
and reduced by 6dB.
LEFT
(left only) – Passes only the left channel of a stereo source to both L
and R.
RIGHT
(right only) – Passes only the right channel of a stereo source to
both L and R.
Choose the desired mode by, first, pressing and holding channel’s
A/B/SET button until it begins to flash, then pressing the MODE button to
cycle through the choices. The channel’s display will change to reflect the
new mode. Choose the desired mode and press the A/B/SET again.
This operation may be denied to a user in the Talent Access tab of the
Wheatnet IP L8 Setup Tool
GUI.
Event
The L‑8 includes a snapshot save and recall feature that saves all of the
surface’s switch, settings to a unique Event file. These saved Events may be
recalled as required at any time.
To recall an Event, press and release the EVNT button (the button will
light), then dial up the FUNCTION knob until
the desired event shows in the top display.
Press the TAKE button to complete the pro‑
cess. An Event will not change the status of a
channel that is ON when the Event is recalled.
To save an Event, press and hold the EVNT
button until it flashes, then dial up the Event
you want to save to and press TAKE. The cur‑
rent surface switch settings at the time the save is done will be reestablished
when that Event is recalled, except for any channels that are on at the time
of recall.
User access privileges may be configured to limit access to Save and/or
Take Events in the Talent Access tab of the
Wheatnet IP L8 Tool
GUI.
L8-IN Module
