Lit. No. 49513, Rev. 04
77
June 15, 2022
MVP PLUS™ CUTTING EDGE WEAR
AND LEVELING ADJUSTMENT
After the snowplow has been installed on the
vehicle in the correct configuration, a fine
adjustment can be made to bring the cutting
edges of the snowplow in full contact with the
ground across the entire cutting edge. This
adjustment feature should be used as the cutting
edges begin to wear in order to maintain an even
wear pattern across both cutting edges and
provide good scraping action.
1. Snowplow must be installed on a properly
ballasted vehicle, in the correct configuration.
2. Vehicle and snowplow must be on a level
surface.
3. If the optional shoe kit has been installed
on the blade, remove the shoes during this
adjustment procedure.
MAINTENANCE
4. Place the blade wings in scoop position on the
ground with no tension on the lift chains.
5. Remove the rear fasteners holding pushbeam
to T‑frame. Loosen the front fasteners and
allow the blade to find a level position.
T‑Frame
Push
Beam
Rear
Fasteners
Front
Fasteners
Summary of Contents for UltraMount
Page 3: ......
