Lit. No. 49513, Rev. 04
58
June 15, 2022
OPERATING YOUR SNOWPLOW
SHOE ADJUSTMENT
Recommended Shoe Adjustments
For gravel surfaces:
The bottom surface of the
shoe should be ¼"–½" (0.6–1.3 cm) below the
cutting edge.
For hard surfaces (concrete or asphalt):
The
bottom surface of the shoe should be even with
the cutting edge.
WARNING
Blade can drop unexpectedly. Place blade
on jack stands. Failure to do so could
result in serious personal injury.
Adjustment Procedure
1.
Raise the blade one foot (30 cm) off the road
surface, turn the control OFF, and from in
front of the blade, place jack stands under the
cutting edge.
2. Turn the control ON and lower the blade onto
the jack stands. Turn the control and vehicle
ignition OFF.
3. Remove the linchpin and slide the shoe
down and out of the shoe hole (straight
blades) or shoe holder (MVP PLUS™ and
WIDE‑OUT™ blades).
4. Remove one or more washers from the shoe
stem and reinstall the shoe into the shoe
hole/holder.
5. Place the removed washers onto the shoe
stem above the shoe hole/holder.
Summary of Contents for UltraMount
Page 3: ......
