Lit. No. 49513, Rev. 04
43
June 15, 2022
OPERATING YOUR SNOWPLOW
Wing Positions
Moving the control lever from the center position
toward the word WING on either side of the face
of the control body will cause either wing to move
independently of the other, as described in the
following table.
NOTE: If a control function times out before
the desired blade movement is complete,
release the lever to the center position, then
move it back into the desired function.
SECURITY GUARD™ System (1, 2, 3, 4)
Moving the control lever from the center position
toward any of the four digits on the face of the
control will also operate the SECURITY GUARD
system. See "SECURITY GUARD System" in this
section for more information.
Function Description of Operation
L WING
Move the control lever to the left of
LOWER
on the control face to move the left wing.
The first time the lever is moved into
the slot after the control is turned ON or
another function is used, the wing will
extend. Repeated use of the lever in the
same slot, without using another function,
results in movement in the opposite direction
from the previous movement.
R WING
Move the control lever to the right of
LOWER
on the control face to move the
right wing. The first time the lever is moved
into the slot after the control is turned ON
or another function is used, the wing will
extend. Repeated use of the lever in the
same slot, without using another function,
results in movement in the opposite
direction from the previous movement.
Summary of Contents for UltraMount
Page 3: ......
