Lit. No. 49513, Rev. 04
47
June 15, 2022
5. After entering the correct security code, the
power indicator light will change from flashing
rapidly to a solid light to indicate the snowplow
has been successfully unlocked.
NOTE: If the plow/vehicle electrical
connection is lost or disconnected, the
SECURITY GUARD™ system will reset,
requiring any control that is not programmed
with the established 4-digit security code to
manually re-enter the security code to activate
the snowplow.
Clearing an Established 4-Digit Security Code
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position.
2. If the snowplow is locked (the control power
indicator light will be flashing at a fast rate),
unlock the snowplow by following the Manual
Unlock procedure.
3. Move the ON/OFF switch to the "OFF"
position or push the ON/OFF button to switch
the control OFF. Verify that the power indicator
light is OFF.
4. With the control OFF, move the control lever
to the #2 position or press the #2 button four
times, and then to the #3 position or the #3
button four times. This sequence (2, 2, 2, 2, 3,
3, 3, 3) will clear the 4‑digit security code from
the SECURITY GUARD system. The FLOAT
light will flash to indicate that the 4-digit
security code was cleared.
NOTE: To enter a new 4-digit security code
see Activation & Establishing a 4-Digit
Security Code.
OPERATING YOUR SNOWPLOW
Summary of Contents for UltraMount
Page 3: ......
