Lit. No. 72131, Rev. 00
July 15, 2018
70
Changing from Short Chute to Long
Chute Con
fi
guration
−
Electric Models
1. Remove chute from spreader if installed.
2. Remove the two 1/4"-20 bolts that attach
the motor cover plate to the upper section of
the chute. Cut the wire ties holding the extra
harness length and extend. Disconnect the
motor leads from the harness.
3. Remove and retain the four fasteners that
attach the upper and lower sections together.
Separate the two sections, being careful not to
damage the electrical harness.
4. Open the shaft extension kit and inventory the
parts in the kit (middle section and bolt bag).
5. Attach the middle section to the lower section
using four 3/8"-16 x 3/4" cap screws, 3/8" nuts,
3/8" lock washers, 3/8"
fl
at washers, and two
1/4"-20 x 3/4" cap screws, 1/4" four
fl
at
washers, and two 1/4"-20 locknuts.
6. Install the rubber bushing into the 1" diameter
hole in the back corner of the midsection.
Route the electrical harness from the upper
section down through the bushing. Reconnect
the harness to the motor leads and verify
that the harness will not contact any moving
parts. Reinstall the motor cover plate that was
originally attached to the upper section.
7. Attach the middle section to the upper section
using four 3/8"-16 x 3/4" cap screws, 3/8" nuts,
3/8" lock washers, and 3/8"
fl
at washers.
8. Verify that the spinner moves freely.
9. Reinstall the chute on the spreader.
10. Run the spreader to verify correct operation.
Pay attention to the spinner. It should turn in
a clockwise rotation. If not, swap the spade
connections at the motor leads.
Changing Long Chute to Short Chute
Con
fi
guration
The chute must be separate from the hopper for
this procedure.
1. Remove the six fasteners that attach the
lower and middle chute sections and the four
fasteners that attach the middle and upper
sections. Remove the middle section.
2. Install the lower chute section to the upper
section using the four upper fasteners removed
in Step 1.
3. Loop up the excess length of the cable and
secure it to the corner bracket using cable ties.
Remove the cover from the middle section and
reinstall on upper section.
Remove
middle
section.
Reinstall
fasteners
(2 per side).
Excerpts taken from Striker™ Hopper Spreader Installation Instructions (Lit. No. 99586/99592, Rev. 02).
STEEL HOPPER SPREADERS – CHUTE ADJUSTMENT: ELECTRIC MODELS
Summary of Contents for LOW-PRO 300W
