Lit. No. 72131, Rev. 00
July 15, 2018
65
5. Using a straight edge, check the alignment of
the spinner shaft and spinner drive sprockets.
6. To adjust sprocket alignment, loosen the
spinner sprocket set screw, adjust the sprocket
position up or down as required, and retighten
the set screw.
7. Install the drive chain over the spinner shaft
and spinner drive sprockets.
Install Chute to Spreader – Gas Models
1. Unlatch the access door on both sides. Lift the
door and slide it inward to hold it open.
2. Pick up the chute from each side and slide the
chute-side hinge plates over the hopper-side
hinge plates. Two people are recommended for
this step.
Chute
Hinge Plates
Access
Door
Engine
Cover
Door
Latch
Back
Latch
Chute
Pin
3. Line up the hinge pivot holes. Insert a
1/2" x 8-1/4" chute pin on each side, with the
passenger-side pin inserted from below. Secure
the chute pins with 3/32" x 2-1/4" cotter pins.
4. Release both back latches and lift the engine
cover.
Check alignment
of sprockets.
Excerpts taken from Striker™ Hopper Spreader Installation Instructions (Lit. No. 99587/99593, Rev. 02).
STEEL HOPPER SPREADERS – CHUTE INSTALLATION: GAS MODELS
Summary of Contents for LOW-PRO 300W
