![background image](http://html.mh-extra.com/html/security-brands/secure-pass-cr1/secure-pass-cr1_quick-start-manual_1231975001.webp)
1 of 2
Model
40-100
Q U I C K S TA R T
G U I D E
1
A2
A3
A7
A5
A6
A4
IMPORTANT
r
r
Unpack box and make sure you have all items shown here.
(Hex nuts to mount to controller faceplate should be with faceplate)
Drill 5/8-inch pass-through hole in
surface in center of desired reader
mounting location.
Feed Reader Base wiring through
pass-through hole, and wire reader to
Wiegand controller
(not included).
Snap Reader Cover onto Base, lining up
LED lens on Base with slot in Cover.
Parts will snap together securely.
Hold Reader Base against mounting
surface, and use nail to tap two marks.
Reader Cover
Self-Tapping Screw
( 2x )
Mount Reader Base to surface using
Self-Tapping Screws. Use drywall
anchors
(not included)
if desired
.
Power up Wiegand controller, and
make sure Reader is working correctly
by scanning a valid card
(not included).
Faceplate Screw
( 2x )
Reader Base
Refer to Wiegand controller instructions for wiring
details. If controller only has one LED terminal, connect
gray wire (green LED) for standard operation.
Nail not included.
If mounting the proximity card reader to a
surface like a wall or door frame, proceed to
Step A2
on this page.
If mounting the proximity card reader to a
controller faceplate, remove the cover plate or
current card reader, keep the hex nuts handy,
and proceed to
Step B2
on the next page.
Pre-drill
appropriately
sized holes
if using anchors
or if mounting
to metal.