132
6620-3201
D->1B up rate (bytes/s):
When Always on mode is “On”, this is the value (in bytes/s) above which the data transfer rate must
remain for D->1B up delay (s) before the unit will activate a B-channel.
D->1B up delay (s):
When Always on mode is “On”, this is the time (in seconds) for which the data transfer rate must
remain above the speci
fi
ed D->1B rate before the unit will activate a B-channel.
1B->D down rate (bytes/s):
When AODI always on is On, this is the value (in bytes/s) below which the data transfer rate must
remain for 1B->1D down delay (s) before the unit will deactivate the B-channel.
1B->D down delay (s):
When Always on mode is On, this is the time (in seconds) for which the data transfer rate must remain
below the speci
fi
ed 1B->D rate before the unit will activate a B-channel.
Using Text Commands
From the command line use the
mlppp
command to set or display MLPPP parameter settings.
To display current settings for MLPPP enter the following command:
mlppp <instance> ?
where
<instance>
is 0. To set the value for a parameter enter the
command in the format:
mlppp <instance> <parameter> <value>
For example:
mlppp 0 username fred
The parameters and values are:
Parameter
Values
Equivalent Web Parameter
ddown_delay
number
1B->D down delay (s)
ddown_rate
number
1B->D down rate (bytes/s)
down_delay
number
2B->1B delay (s)
down_rate
number
2B-> 1B rate (bytes/s)
dup_delay
number
D->1B up delay (s)
dup_rate
number
D->1B up rate (bytes/s)
epassword text
None - this is the password in encrypted
format. This parameter is not con
fi
gurable.
l_accm
hex number
Desired local ACCM
l_shortseq
off, on
Short sequence numbers
password text
Password
r_accm
hex number
Desired remote ACCM
r_chap
off, on
Request remote CHAP authentication
up_delay
number
1B -> 2B delay (s)
up_rate
number
1B -> 2B rate (bytes/s)
username text
Username
