WESAUDIO
4/10/20
NGLEVELER USER MANUAL REV2
23
5.2.3.3.
Set up static IP address.
To set up IP address for ngLEVELER, first connect it directly to your workstation using
USB cable. Then start GConManager and select “_CONFIG” application. Select your
ngLEVELER unit at the device list on the left side of the screen, then change IP address:
To change any network specific configuration of your ngLEVELER:
1)
Connect your ngLEVELER directly to your workstation through USB cable (If
connection to ngLEVELER is already established through Ethernet cable, this step is
not necessary),
2)
Start GConManager and go to _CONFIG application.
3)
Then select your ngLEVELER unit from the left side of the screen.
4)
Then change DHCP option to “OFF” (if it is currently “ON”). Unit will restart, and your
connection will re-establish.
5)
Enter IP address that you would like to set, hit Apply button. Unit will restart, and your
connection with ngLEVELER will be established again.
Now you can disconnect USB cable, and connect ngLEVELER using Ethernet cable.
Summary of Contents for ngLEVELER
