64
NOTE:
The cabinet must be properly leveled first, or the doors will not fit properly. See page 58.
1. Lay the door (#33) flat. Use a plastic mallet to pound 8-32 screw inserts (#11) into the eight holes
(four pairs) near one edge of the door (install inserts into the front face of the door).
2. Attach four hinges (#35) to the inside (back face) of the door, using flat-head
3
/
4
" screws
(#49 matches hinge color) into the inserts installed in step 1.
3. Four sets of screw inserts (#10 oyster) were previously installed in the left side panel for the door
hinges.
See Detail A
on the cabinet assembly instructions.
See Detail G.
Hold the door in position on the cabinet. Attach the four hinges to the side panel, using
three painted flat-head screws (#49 matches hinge color) into each set of screw inserts.
A screw may be inserted into the rear-most hole of the cabinet and the door may be hung from it by
placing the slotted hole in the hinge onto the screw and moving the hinge forward until the other two
screw inserts are exposed. Tighten the three screws in each hinge.
4. Secure each hinge to the edge of the door, using painted flat-head 5/8" screws (#5) into the
predrilled hole.
5.
See Detail H.
Insert a card holder housing (#39) into the two inner holes in the front face as shown.
Insert hex-socket cap nuts (#41 matches hinge color) into the holes in the back face of the door and
tighten them.
6. Insert the handle (#34) into the remaining two holes in the door install and tighten the cap nuts.
T
O
A
TTACH
O
NE
F
ULL
-L
ENGTH
W
OOD
D
OOR
Detail G
Left side hinge installation
Detail H
Lock housing &
handle installation
Item
Description
5
screw, flat-head,
5
/
8
"
(matches hinge color)
10
insert, screw, 8-32 (oyster)
11
insert, screw, 8-32
33
door
34
handle
35
hinge
39
housing, lock
41
nut, cap, hex-socket
49
screw, flat-head,
3
/
4
"
53
holder, card
71
screw, pan-head,
3
/
4
"
—
lock housing
(consists of #39 and 53)
To identify the front and back faces of
the door, see also Detail G on page 50.
NOTE:
The above procedures are shown for a left side hinge. For a right side hinge, the above images
would be mirrored.
