60
NOTE:
The cabinet must be properly leveled first, or the doors will not fit properly. See page 58.
NOTE:
Be sure that double door stops were installed while the cabinet was being assembled.
1.
See Detail G.
Lay the door (#33) flat. Use a plastic mallet to pound 8-32 screw inserts (#11) into the
predrilled holes in the door (install inserts into the front face of the door). If the cabinet has two
double compartments, each door has three hinges; if three double compartments, two hinges.
2. Attach hinges (#35) to the inside (back face) of each door, using flat-head
3
/
4
" screws (#49 matches
hinge color) into the inserts installed in step 1.
3.
See Detail G.
Hold a door in position on the cabinet. Attach the hinges to the screw inserts already installed
in the side panel, using three flat-head screws (#49 matches hinge color) into each set of screw inserts.
A screw may be inserted into the rear-most hole of the cabinet and the door may be hung from it by
placing the slotted hole in the hinge onto the screw and moving the hinge forward until the other two
screw inserts are exposed. Tighten the three screws in each hinge. Repeat with the other door.
The screw inserts (#10 oyster) were previously installed in the left and right side panels for the door
hinges (three screws per hinge). See
Detail A
on the cabinet assembly instructions.
4. Secure each hinge to the edge of the door, using
5
/
8
" flat-head screws (#5 matches hinge color) into
the predrilled hole.
5.
See Detail H.
On each left door, insert a lock housing (#39) (pre-assembled at the factory) into the
two holes in the front face of the door. Insert hex-socket cap nuts (#41 matches hinge color) into the
holes in the back face of the door and tighten them.
or-
Insert a card holder housing (#70) into the two holes in the right door. Install and tighten the cap nuts.
Closing the doors and latching the slide lock aligns holes in the slide lock (#52) and lock housing for
installing a padlock.
6. To attach the identity card holder (#53), center and hook it over the top edge of the housing (#39 or
#70) and push it down and in until the bottom attaches.
T
O
A
TTACH
D
OUBLE
C
OMPARTMENT
W
OOD
D
OORS
Detail G
Hinge installation
Detail H
Lock housing installation
Item
Description
5
screw, flat-head,
5
/
8
"
(matches hinge color)
10
insert, screw, 8-32 (oyster)
11
insert, screw, 8-32
33
door
Item
Description
35
hinge
39
housing, lock
41
nut, cap, hex-socket (matches hinge color)
49
screw, flat-head,
3
/
4
" (matches hinge color)
Item
Description
53
holder, card
70
housing, card holder
—
lock housing
(consists of #39, 52 & 53)
53
41
52
70
39
