36
Maintenance (continued)
Magnetic Gasket Replacement
1. Open the top leg of the aluminum gasket retainer with a wide flat bladed screwdriver.
Do not destroy basic shape of lip.
2. Open the legs of the vertical retainers at the extreme bottom where the gasket is held from
dipping below the retainer.
3. Slide the gasket upwards out of the retainers.
4. Thread the new gasket into the retainers starting from the top, fitting the open ends
simultaneously into the channels on both sides.
5. Use extreme care in pulling the gasket into the retainers to avoid damage to the thin webbing.
Grasping the gasket around the magnet and pulling out away from the door and then down
will help avoid damage. The gasket should be held up about 6" (152 mm) above the door
so that it can be fed straight into the vertical retainers.
Sweep Seal Gasket Replacement
1. Remove the four screws at the sweep on the latch side, remove the plate and remove
one screw at the sweep, holding the sweep at the hinge side.
2. With the door open about 12" (305 mm), push down on end of the sweep seal and pull it out from
the end (or latch side) of the door. It will help to fold the flange seal foam up and out of the
way to ease pulling sweep seal from the door. This will also ease installing a new seal.
3. Reverse this process to replace with a new sweep seal.
Key Replacement
A list of key numbers should be made immediately following installation and kept in a safe place.
Should any keys be misplaced, contact the nearest lock distributor.
