24
Single End Cover Panel Attachment
1. To further secure the single end cover panel, screws must be installed through the rear of the end locker.
a. From the outside of the locker at the end of the locker formation, measure and mark for three holes.
These holes should be parallel with the existing holes in the front of the locker and 2-1/2"-3" in
from the back of the locker as shown.
b. Drill three 5/32" holes completely through the locker.
2. Raise the single end cover panel into position covering the cabinet side and flush with the front edge.
Be sure that the front holes in the single end cover panel (17) are aligned with the front holes in the locker.
3. Attach the front of the single end cover panel to the locker using
three 1/4-20 x 1.181" connector bolts (15) and 1/4-20 cap nuts (16).
4. Attach the back of the end cover panel using three #8 x 1-3/8" wood screws (26)
through the locker holes drilled in Step 1 and into the end cover panel.
Single End
Cover Panel
(17)
#8 x 1-3/8"
Wood Screw
(26)
1/4-20 x 1.181
Connector Bolt
(15)
1/4-20
Cap Nut
(16)
Overtightening the screws could
cause them to poke through the
outside of the end cover panel.
Existing
hole
Drill new
5/32" hole
2-1/2"-3"
End of
locker formation
End of
locker formation
Existing
holes
2-1/2"-3"
New drilled
hole
No
existing hole
!
CAUTION
Optional Side Closure Panel Accessory Installation for
Lockers without Metal Base (continued)
Existing
hole
Drill new
5/32" hole
Existing
hole
Drill new
5/32" hole
Existing
hole
Drill new
5/32" hole