10
Figure 1-6-6 Quick-Reset
Check Welltech 2540 Registered Status:
Step 7: After soft-reset or reboot.
>Click Status > SIP Trunk Status to check whether registered or not. (See
figure 1-6-7 SIP trunk status)
Figure 1-6-7 SIP trunk status
Through the above settings, the Welltech 2540 should able to do the following:
For FXO (Welltech 2540):
1.
For PSTN incoming call, the caller will hear a dial tone. Then the caller can
dial a VOIP number and it will use the setup SIP Trunk 1 to make SIP call
out. (2 stage dialing)
2.
For VOIP incoming call, Welltech 2540 will off hook a FXO port and dial to
PSTN.
Summary of Contents for WellGate 2540
Page 1: ...Welltech 2540 FXO Gateway User Guide...
Page 59: ...59 4 copy firmware successfully 5 reboot 7 Check whether the system was recovered or not...
Page 77: ...77 Figure 23 Three options of Caller ID Mode...
Page 79: ...79 Figure 25 Loop Current Drop to release FXO port Figure 26 Loop Current Drop detection Time...
