63
WellGate 2540 (4-FXO Gateway ) information :
IP address : 192.168.23.23
SIP Line number : 1001, 1002, 1003 and 1004
FXO Telephone Number : default is Blank
PABX Extension number 201, 202, 203 and 204 which were connected to Port
#1 to #4 at FXO Gateway.
WellGate 2504 (FXS Gateway) configuration
Step 1: Configure static IP address to WellGate 2504, like below Figure 2.
For example: Set static IP address of 192.168.18.201 at
WAN port
on Device
Setting
Network of WellGate 2504 WEB page.
Figure 2.
Step 2: Go to VOIP Setting
SIP to select the “Accept Proxy Only”
feature to
NO
and make sure to setup the SIP Local Port number. In this
example, the SIP local port is 8080. See Figure 3. This port number should be
the same as Phone book configuration SIP port number.
Figure 3.
Step 3: Set the FXS line’s information to each port ( Line ID is the FXS’s port
number at Figure 4).
Enable Hotline feature at FXS gateway to port #1 and enter
HOT LINE TEL
Summary of Contents for WellGate 2540
Page 1: ...Welltech 2540 FXO Gateway User Guide...
Page 59: ...59 4 copy firmware successfully 5 reboot 7 Check whether the system was recovered or not...
Page 77: ...77 Figure 23 Three options of Caller ID Mode...
Page 79: ...79 Figure 25 Loop Current Drop to release FXO port Figure 26 Loop Current Drop detection Time...