6
green.
Proxy
When the gateway is registered successfully to a Proxy,
this will light up green.
WAN
This will light up green when the gateway’s WAN port is
physically connected to the public internet. When data is
transmitted through this port, it will flash green.
The default IP of WAN port is 10.1.1.3.
LAN
This will light up green when the gateway’s LAN port is
physically connected to a local network (Refer to Rear
Panel section in page number for location of LAN port).
When data is transmitted through this port, it will flash
green.
The default IP of LAN port is 192.168.123.123.
Line1~Line4
The status LED for FXO port 1-4, this will light up amber
orange when the connected phone is engaged in a
conversation. It will flash amber orange when there is an
incoming call.
1-5 Rear Panel: LED Indicators
WellGate 2540
Figure 1-4-1 rear panel for FXO
Item
Description
Reset
Press and hold over 5 seconds to reload factory default
setting, this will erase all existing settings configured on
this gateway.
L1 - L4
The status LED for FXO port 1-4. When there is no PSTN
connected, this LED will become blinking. When PSTN is
connected and no talking, the LED will be off. When a line
is using, the LED will become light up. (WellGate 2540
only)
LAN
10/100 Base-T RJ-45 socket for LAN port, connects to PC
for management purpose.
Summary of Contents for WellGate 2540
Page 1: ...Welltech 2540 FXO Gateway User Guide...
Page 59: ...59 4 copy firmware successfully 5 reboot 7 Check whether the system was recovered or not...
Page 77: ...77 Figure 23 Three options of Caller ID Mode...
Page 79: ...79 Figure 25 Loop Current Drop to release FXO port Figure 26 Loop Current Drop detection Time...