EN
19
that could change the amount or direction of
the air flowing through the heater.
A bare heating element can endanger
combustible materials even outside the safety
distances. Check that no heating elements can be
seen behind the stones.
1.1.1. Maintenance
Due to large variation in temperature, the sauna
stones disintegrate in use.
Rearrange the stones at least once a year or even
more often if the sauna is in frequent use. At the
same time, remove any pieces of stones from the
bottom of the heater and replace any disintegrated
stones with new ones. By doing this, the heating
capability of the heater stays optimal and the risk
of overheating is avoided.
Pay attention especially to the gradual settling
of the stones. Be sure that the heating
elements do not appear with time.
The stones settle
most rapidly within two months of piling.
1.2. Heating of the Sauna
When operating the heater for the first time, both the
heater and the stones emit smell. To remove the smell,
the sauna room needs to be efficiently ventilated.
If the heater output is suitable for the sauna room,
it will take about an hour for a properly insulated
sauna to reach the required bathing temperature (
2.3.). The sauna stones normally reach the bathing
temperature at the same time as the sauna room.
A suitable temperature for the sauna room is about
60–75 °C.
1.3. Using the Heater
Before switching the heater on always check
that there isn’t anything on top of the heater
or inside the given safety distance. 1.6.
Heater models PC70EE/VEE/HEE/VHEE and
PC90EE/VEE/HEE/VHEE are equipped with a sepa-
rate control panel and an internal electronic power
regulation unit, which is controlled by a computer
and a separate temperature sensor.
Anyone using the heater can program the sauna’s
temperature and the operating time according to
preference from the heater’s control panel (see fig-
ure 2). Furthermore, by pressing a button on the
panel the heater can be programmed to come on at
the desired pre-setting time. The heater’s factory
settings are as follows:
•
temperature about +65 ºC
•
on-time 4 hours
•
pre-setting time 0 hours
The settings menu structure and changing the set-
tings is shown in figures 3a and 3b. The programmed
temperature value and all values of additional set-
tings are stored in memory and will also apply when
the device is switched on next time.
Summary of Contents for 52-210094
Page 31: ......
