WELDKAR 151656231, Instruction Manual

Page: 20 / 46

20
eng
deu
ned
WARNING If damaged, GAS FLUES
can explode.
Screen gas cylinders contain gas under high pressure. If
damaged, a gas cylinder can explode. As gas cylinders
are normally part of the welding process, you must
handle them with care.
1. Protect compressed gas cylinders from excessive
heat, mechanical shocks and welding bends.
2. Secure the gas bottle in the vertical position with a
chain to a fixed support or the bottle rack of the
of the equipment to prevent it from falling or
to prevent it from falling or tilting.
3. Keep gas cylinders away from all welding or other
electrical circuits.
4. A welding electrode must never touch a gas cylinder.
5. Use only the correct protective gas cylinders,
-regulators, hoses and accessories which must be
are designed for their specific use; Ensure that
these and their associated parts in good condition.
6. When opening the gas cylinder valve, turn the face
away from the outlet of the valve.
7. Always leave the protective cap in place over the
valve, except when using the gas cylinder or
connecting it for use.
8. Read and comply with the instructions on bottles of
with compressed gas, the corresponding equipment
listed in the safety standards.
WARNING
MOVING PARTS
can cause injury
Moving parts, such as fans, rotors and strings can cut
off fingers and hands and catch flapping clothes.
1. Keep all doors, panels, covers and protective covers
closed and securely in place.
2. Stop the engine before installing or connecting the
unit.
3. If necessary, only authorized persons may remove
covers or covers for maintenance and
troubleshooting.
4. To prevent unintentional starting during
maintenance, disconnect the negative (-) battery
cable from the battery.
5. Keep hands, hair, fluttering clothes and tools away
from moving parts.
6. Reinstall the panels or covers and close the doors
when servicing is completed and before starting the
engine.
WARNING FROSTING can
cause ACCUVACY GAS to
explode; ACCUVACY ACID can
burn the eyes and skin.
Batteries contain acid and generate explosive gases.
1. Always wear a face shield when working on a
battery.
2. Stop the engine before disconnecting or connecting
battery cables.
or connecting the battery cables.
3. Make sure that the tool does not create sparks
when working on a battery pack.
4. Do not use the welder to charge batteries or to start
vehicles.
5. Pay attention to the correct polarity (+ and -) on the
batteries.
NOTE
Considerations on welding and the effects of low-
frequency electric and magnetic fields
The electric current flowing through any conductor
produces electromagnetic fields (EMF). The welding or
cutting current produces electromagnetic fields around
the cables and the generators. The magnetic fields
produced by high current can affect the functioning
of pacemakers. Wearers of vital electronic equipment
(pacemakers) should consult their doctor before
approaching arc, cut, burn or spot welding work.
Exposure to electromagnetic fields, produced during
welding or cutting, can affect health in unknown ways.
To reduce magnetic fields in the workplace, you should
follow the following procedures.
1. Keep cables close together by twisting them.
2. Keep the cable on one side and away from the
user.
3. Do not roll or hang cables around the body.
4. Keep the welding power source and cables as far
away from the body as possible from the body as far
as practical.
WARNING
ABOUT PACEMAKERS
The above procedures are among those normally
recommended for pacemaker wearers. Consult your
physician for more information.
!