WELDKAR 151656231, Instruction Manual

Page: 17 / 46

INVERTER WK PLASMA 5035 COM PFC
17
WARNING
PROTECT YOURSELF AND OTHERS FROM POSSIBLE SERIOUS INJURY OR DEATH. KEEP
CHILDREN AWAY. PACEMAKER WEARERS SHOULD MAINTAIN AN APPROPRIATE DISTANCE UNTIL
THEY HAVE CONSULTED A PHYSICIAN. UNTIL THEY HAVE SPOKEN TO A PHYSICIAN. MAKE
SURE THE MANUAL IS NOT SHOW UP. READ THE USER MANUAL BEFORE INSTALLING, USING OR
SERVICING THE EQUIPMENT. INSTALL, USE OR MAINTAIN THE EQUIPMENT
If the operator does not strictly adhere to the safety instructions and take precautions, welding products and processes
may cause welding products and processes can cause serious injury or death or damage to other equipment or property.
Safe working methods have been developed based on past experiences with welding and cutting. These methods must be
learned through study and training before using this equipment. Some of these Some of these methods apply to equipment
connected to power lines; others apply to engine-driven equipment. Motor-driven equipment. Persons without extensive
training in welding and cutting methods should not attempt to weld. The safe working methods are set out in the European
standard EN 60974-1, entitled: Health and safety in welding and allied processes - Part 2: Electrical.
This machine may only be used for cutting. It is essential to pay attention to and observe the safety instructions. The
symbols indicate points that require extra attention, practical advice or simple information. This manual and the safety
instructions must be carefully stored in a place known to everyone who uses the machine. They must be consulted in case
of doubt and kept for the entire life of the machine.
ALL INSTALLATION, OPERATION, MAINTENANCE AND REPAIR WORK MAY ONLY BE CARRIED OUT
BY QUALIFIED PERSONS.
While the information contained in this manual reflects the best judgement of the manufacturer, the latter assumes no
responsibility for its use.
Reproduction in whole or in part of this work without the prior written consent of the publisher is prohibited.
The publisher does not accept, and hereby disclaims, any liability to any party for any loss or damage caused by any error
or omission in this manual, whether such error arises from negligence, accident or otherwise.
All rights reserved.
Copyright 2021
Weldkar Welding Equipment
www.weldkar.com.
TABLE OF CONTENTS
1 Safety instructions and warnings 3
1.1 Hazards associated with arc welding and cutting 3
1.2 Overview of symbols 6
2 Installation 7
2.1 Torch mounting 7
2.2 Description of symbols on the machine 7
2.3 Safety symbols 7
2.4 Explanation of technical specification plate 8
2.5 Thermal protection 8
2.6 Starting up 8
2.6.1 Generators 8
3 Operation 8
3.4 Replacement of wearing parts 9
4 Cutting errors 9
4.1 Insufficient penetration 9
4.2 The arc goes out 9
4.3 Angled cut 9