IBM 4680 PORT 5B SUFFIX
UPC–A
0D
. . . . .
UPC–D
UPC–E
0A
. . . . .
EAN 8
0C
. . . . . .
EAN 13
16
. . . . .
Code 39
00, 0A, 0B
. . .
Interleaved
2 of 5
00 0D 0B
. . . . . .
Code 128
00, 18, 0B
. . .
8300 Series Information and Examples
OUTPUT
PARAMETERS
PREFIX/SUFFIX
Prefixes and suffixes are characters added by the 8300 to MICR and bar code
data. Prefixes and suffixes are assigned to specific symbologies. Use the
Symbology Chart on page 15 to program the symbology for which you’re
adding the prefix/suffix. Use the HEX–ASCII table on page 15 to find the
ASCII value to be used for programming a particular prefix or suffix.
Required Prefixes/Suffixes for Particular Retail Terminals:
continued
14
EXAMPLE: 1)
To program a carriage return suffix for UPC–A symbology only,
scan:
OUTPUT PARAMETERS ENTER, XI, 6, 3, 0, D, F, F, EXIT,
END PROGRAMMING
Where:
OUTPUT PARAMETERS ENTER enters the programming mode
XI enters suffix programming
63 selects UPC symbology (see page 15, Symbology Chart)
0D designates Carriage Return (see Hex–ASCII chart, page 15 )
FF terminates suffix programming
EXIT, END PROGRAMMING leaves the programming mode
To place the MICR error/status as a prefix/suffix, program an “EC” in place of a
value from the HEX–ASCII table on page 15.
Note for MICR Data Only:
EXAMPLE: 2)
To program a carriage return suffix for ALL symbologies, scan:
OUTPUT PARAMETERS ENTER, XI, 9, 9, 0, D, F, F, EXIT,
END PROGRAMMING
Where:
OUTPUT PARAMETERS ENTER enters the programming mode
XI enters suffix programming
99 selects ALL symbologies (see page 15, Symbology Chart)
0D designates Carriage Return (see the HEX–ASCII table on page
15)
FF terminates suffix programming.
EXIT, END PROGRAMMING leaves the programming mode
EXAMPLE: 3)
To program the MICR error/status code prefix for E13–B
symbology only, scan:
OUTPUT PARAMETERS ENTER, X, 7, 4, E, C, F, F, EXIT,
END PROGRAMMING
Where:
OUTPUT PARAMETERS ENTER enters the programming mode
X enters prefix programming
74 selects E13–B symbology (see page 15, Symbology Chart)
EC designates MICR error/status code (MICR ERROR/STATUS
Codes parameter must be programmed to single or double character
in order to get any MICR error/status code output.)
FF terminates prefix programming.
EXIT, END PROGRAMMING leaves the programming mode
NCR 2123 MSR TRACK 2
Prefix
62, 00
. . . . .
Suffix
3D
. . . . .
Summary of Contents for SCANTEAM 8300
