8300 Series Information and Examples
OUTPUT
PARAMETERS
continued
18
OUTPUT MODES
WAND/LASER PORT MODES
MICR ERROR/STATUS CODES
Use this option to output either a single or double character when there is a
MICR Error/Status code to report. This selection also allows you to dump out
any MICR data read on an error condition.
Hand Held Laser Timeout: This programs a timeout for a hand-held laser
compatible scanner. The scanner turns off after the trigger is depressed for 4
seconds.
Laser Redundancy: If programmed ‘’Yes,” the 8300 requires three identical
scans before data will be accepted.
If disabled, the 8300 accepts data after a
single valid scan.
When the MICR code on the check is in error and a triple beep occurs, the
error code will only be output when this selection is set to single or double
character.
Note: For Error Conditions
When the MICR code on the check is not in error but does have some other
status condition to report (i.e., serial number in range 151–300), this status
code will only be output when this selection is set to single or double character
AND the placement of the status code is set by either a prefix/suffix or data
formatter command.
Note: For Status Conditions
All MICR error/status code values can be programmed – see the MICR Data
Formatter (page 39) to do this. To place the error/status code at the beginning
or end of a MICR output string, use EC as the ASCII value when programming
in a prefix/suffix. To place the error/status code in the middle of a MICR output
string, use the EC Data Formatter Command.
Note: For Placement and programmable MICR Error/Status Codes
TRANSMISSION RATE CONTROLS
The Transmission Rate Controls can be used to speed up or slow down
transmission when the check reader is interfacing keyboard wedge with a
termial ID 03. Use these selections to control how much delay there is
between make/break sequences when wedging in keyboard data.
Interrupt Time: Use this selection to control the amount of interrupt time
between characters output.
Delay time Shift/CTRL Sequence: Use this selection to control the amount of
delay time between make/break codes when outputting a shifted or CTRL key
character.
Delay Time Normal Sequence: Use this selection to control the amount of
delay time between make/break codes when outputting a normal data key
character.
Summary of Contents for SCANTEAM 8300
