Standards and compliance
General compliance and standards
Many local laws and regulations require special procedures to recycle or dispose of
electrical equipment-related waste including batteries and other elements of electronic
devices. Follow all of your respective local laws and regulations for the proper disposal of
batteries and any other parts of this system. Do not dispose of this product as unsorted
municipal waste. Prepare this product for reuse or separate collection as specified by
Directive 2002/96/EC of the European Parliament and the Council of the European Union
on Waste Electronic and Electrical Equipment (WEEE). If this product is contaminated,
this directive does not apply..
WARNING
Batteries may explode or cause burns, if disassembled,
crushed or exposed to fire or high temperatures.
WARNING
To disconnect mains from the device, remove the power brick
from the mains connector to assure simultaneous disconnection of all
poles.
EMC compliance
Special precautions concerning electromagnetic compatibility (EMC) must be taken for all
medical electrical equipment. This device complies with IEC EN 60601-1-2:2014.
•
All medical electrical equipment must be installed and put into service in accordance
with the EMC information provided in this Directions for use.
•
Portable and mobile RF communications equipment can affect the behavior of
medical electrical equipment.
The monitor complies with all applicable and required standards for electromagnetic
interference.
47
Summary of Contents for RETeval-DR
