Wegner Crane CFW500 series, Applications Manual, Page: 7 / 84

Quick Parameter Reference, Faults and Alarms
Crane | 7
QUICK PARAMETER REFERENCE, FAULTS AND ALARMS
CRANE VERTICAL MOTION
Parameter Description Adjustable Range
Factory
Setting
User
Setting
Properties Groups Page
P1010 Crane Vertical Motion Version 0.00 to 10.00
ro
SPLC
70
P1011 Last Alarm 0 to 999 ro
SPLC 70
P1014 Second Alarm 0 to 999 ro
SPLC 70
P1017 Third Alarm 0 to 999 ro
SPLC 70
P1020 Crane Vertical Motion Status Word 1 Bit 0 = General Enabled
Bit 1 = Running (RUN)
Bit 2 = Rotation Direction
Bit 3 = LOC / REM
Bit 4 = Fault Condition
Bit 5 = Undervoltage
Bit 6 = Alarm Condition
Bit 7 = Hoisting Command
Bit 8 = Lowering Command
Bit 9 = Brake Release Command
Bit 10 to 15 = Reserved ro
SPLC 71
P1021 Crane Vertical Motion Status Word 2 Bit 0 = Lightweight Operation
Bit 1 = Coast to Stop
Bit 2 = Fast Stop
Bit 3 = Emergency Stop
Bit 4 = Stop by Simultaneous Commands
Bit 5 = Hoisting Slowdown
Bit 6 = Reserved
Bit 7 = Reserved
Bit 8 = Programming Error Release Brake
Bit 9 = Overweight
Bit 10 = Slack Cable Alarm
Bit 11 = Slack Cable Fault
Bit 12 = Inverter in Torque Limit
Bit 13 = Improper Operation
Bit 14 = Reserved
Bit 15 = Reserved ro
SPLC 71
P1022 Communication Network Control Word Bit 0 = Load Hoisting
Bit 1 = Load Lowering
Bit 2 to 15 = Reserved 0 rw
SPLC 33
P1023 Speed Reference Control Configuration 0 = Speed Reference via Electronic
Potentiometer (EP)
1 = One Speed Reference via Digital Input
DI4
2 = Two Speed References via Digital Input
DI4
3 = Three Speed References via Digital
Input DI4 and DI5
4 = Four Speed References via Digital Input
DI4 and DI5
5 = Five Speed References via Digital Input
DI4, DI5 and DI6
6 = Speed Reference via Analog Input AI1
(Step Less)
7 = Speed Reference via Communication
Networks
2 cfg SPLC 30
P1024 Enable use of a Filter in the Hoisting and
Lowering Commands
0.00 to 15.00 s 0.10 s
SPLC 27
P1025 Limit Switches Configuration 0 = Without Limit Switches
1 = Hoisting Slowdown via DI3
2 = Hoisting Slowdown via DI7 0 cfg
SPLC 34
P1026 Motor Rotation Direction Inversion 0 = Off
1 = On 0 cfg
SPLC 27
P1027 Motor Demagnetization Time 0 to 65000 s 600 s
SPLC 27
P1028 Speed Hysteresis for Inverter in Torque
Limit Detection
0.0 to 50.0 % 7.5 %
SPLC 68
P1029 Inverter in Torque Limit Fault (F775) Delay
Time 0.00 to 650.00 s 0.75 s
SPLC 69