WEG Drive Scan, Manual

Page: 46 / 74

6
SETTING THE DRIVE SCAN ON THE MFM
6 SETTING THE DRIVE SCAN ON THE MFM
Before starting to make the Drive Scan settings, it is necessary to register all assets that will be monitored through
the Drive Scan on the WEG Motion Fleet Management platform (
Chapter 3 ).
The Drive Scan can be connected to the internet and MFM platform by setting and using the Drive Scan Wi-Fi
antenna or by connecting a network cable to the GbE0 ethernet port.
For the Drive Scan configuration, follow the instructions below:
Step 1 Connect an Ethernet cable between the computer and the Drive Scan GbE0 port (located next
to the power supply connector), as shown in
Figure 6.1 .
Figure 6.1: Preparing for the Drive Scan configuration
Step 2 Open a web browser on your computer.
Enter the default IP, 192.168.0.10 , into the address bar, as shown in Figure 6.2 .
Press the <Enter> key.
Figure 6.2: Connecting to the Drive Scan
Low Voltage Devices | 6-1