WEG Drive Scan, Manual

Page: 23 / 74

5
CONNECTING A DEVICE TO THE DRIVE SCAN
The maximum number of clients connected simultaneously to the accessory;
The minimum Drive Scan version compatible the with the CFW11 firmware.
For additional information, see the document “Anybus-CC Communication Modules” of the CFW11, which can be
found in the download center at the website
www.weg.net by searching for the keyword “anybus-cc”.
Table 5.4: Ethernet hardware accessories of the CFW11 compatible with the Modbus TCP protocol
Accessory
WEG item
Modbus TCP
clients
CFW11
Firmware
Parameters
MODBUSTCP-05
11550476 (1P)
up to 4
≥
V6.00 Table 5.5
(1 or 2 ports) 14033951 (2P)
ETHERNETIP-05
10933688 (1P)
up tp 2
(1 or 2 ports) 12272760 (2P)
PROFINETIO-05 11550548
Table 5.5: Parameters related to the MODBUSTCP-05, ETHERNETIP-05 and PROFINETIO-05 accessories
Parameter Description Values range
P0723 Anybus identification 0 = Inactive
10 = RS485
19 = EtherNet/IP
21 = Modbus TCP
23 = PROFINET IO
Other = Not compatible with drive scan
P0724 Anybus communication status 0 = Inactive
1 = Not supported
2 = Access error
3 = Offline
4 = Online
P0725 Anybus address 0 a 255
P0840 Anybus status 0 = Setup
1 = Init
2 = Wait Comm
3 = Idle
4 = Data Active
5 = Error
6 = Reserved
7 = Exception
8 = Access Error
P0841 Ethernet baud rate 0 = Auto 1 = 10 Mbps, half duplex
2 = 10 Mbps, full duplex
3 = 100 Mbps, half duplex
4 = 100 Mbps, full duplex
P0842 Modbus TCP timeout 0 a 655 s
P0843 IP address configuration 0 = Parameters
1 = DHCP
2 = DCP
3 = IPconfig
P0844 IP1 address 0 a 255
P0846 IP2 address 0 a 255
P0847 IP3 address 0 a 255
P0848 IP4 address 0 a 255
Low Voltage Devices | 5-4