WEG Drive Scan, Manual

Page: 40 / 74

5
CONNECTING A DEVICE TO THE DRIVE SCAN
Table 5.18: Ethernet hardware accessory of the SSW900 compatible with the Modbus TCP protocol
Accessory
WEG item
Modbus TCP
clients
SSW900
firmware
Parameters
CMB-TCP-N 12966038 2
≥
V1.00
Table 5.19
Table 5.19: Parameters related to the CMB-TCP-N
Parameter Net ID Description Values range
C8.3.4 760 IP address configuration 0 = Parameters
1 = DHCP
C8.3.5 762 IP address 0.0.0.0 a 255.255.255.255
C8.3.6 761 CIDR (subnet mask)
0 = Reserved
1 = 128.0.0.0
2 = 192.0.0.0
3 = 224.0.0.0
4 = 240.0.0.0
5 = 248.0.0.0
6 = 252.0.0.0
7 = 254.0.0.0
8 = 255.0.0.0
9 = 255.128.0.0
10 = 255.192.0.0
11 = 255.224.0.0
12 = 255.240.0.0
13 = 255.248.0.0
14 = 255.252.0.0
15 = 255.254.0.0 16 = 255.255.0.0
17 = 255.255.128.0
18 = 255.255.192.0
19 = 255.255.224.0
20 = 255.255.240.0
21 = 255.255.248.0
22 = 255.255.252.0
23 = 255.255.254.0
24 = 255.255.255.0
25 = 255.255.255.128
26 = 255.255.255.192
27 = 255.255.255.224
28 = 255.255.255.240
29 = 255.255.255.248
30 = 255.255.255.252
31 = 255.255.255.254
C8.3.7 766 Gateway 0.0.0.0 a 255.255.255.255
C8.3.9.1 771 Timeout mode 0 = Inactive
1 = F131 fault
2 = A131 alarm
C8.3.9.2 772 Timeout error action 0 = Only indicates
1 = Ramp stop
2 = General disable
3 = Go to LOC
4 = Go to REM
C8.3.9.3 759 Modbus TCP timeout 0 a 999,9s
5.6.3 POSSIBLE FORMS OF CONNECTIONS
Figure 5.9 illustrates the possible ways to connect the SSW900 to the Drive Scan.
Low Voltage Devices | 5-21