Weber Geset 125, Original User Manual

Page: 53 / 57

Chapter 10 Troubleshooting
40001136 Geset 125
Version: 30.07.14
Page 53 of 57
GB
Problem Possible cause Solution
Label liner tears. Label roll is damaged.
Nicks or label cutter-die
damage on liner.
Dents/damages at the side of
the label roll.
The liner width varies
significantly. Exchange label roll.
Adhesive residues in the area
of the peeler bar. Remove adhesive residues and
check the label roll for damages
caused by adhesive residues.
Otherwise exchange roll.
Label placement on the
product is consistently
poor The product is not yet/ not
anymore incorrect labeling
position. Check sensors of the conveyor
used to determine the product’s
stop position.
Label placement on the
product is consistently
poor Product sensor (or its reflector)
are loose or vibrate. Check sensors and remount, if
required.
Changing conveyor speed
(e.g. depending on load) Check the speed and record.
Contact supplier of conveying
system.
Label with not suitable
adhesive, insufficient initial
adhesion. Change label quality.
Wrong parameterization. Check time- and delay settings of
the responsible configuration
parameters.
No automatic operation
possible. The label cannot
be applied. No trigger of the product
sensor. Check the incoming trigger
signal. Countercheck via [Enter]-
button.
The desired rate of
application cannot be
reached with the labeler. The required rate of
application from the conveyor
exceeds the specifications. Check conveyor speed and the
product gap. Reduce conveyor
speed if possible.
Incorrect configuration
parameter values of the
labeler. Excessive cycle
processing time. Inquire Service Technician at the
Hotline (s. page 7).
Machine functions occur
at random without being
initiated. Product detector loose or
vibrating or being affected of
reflecting light from product
surface. Check the adjustments of the
sensors and inquire if needed a
Service-Technician at the
Service-Hotline (s. page 7).
Loose wiring connections. Check all connections at labeler.