Weber Geset 125, Original User Manual

Page: 45 / 57

Chapter 8 Operation
40001136 Geset 125
Version: 30.07.14
Page 45 of 57
GB
Stop labeling operation
Requirements
¥
Labeling system is in labeling operation (s.a.)
Instruction
Please stop labeling operation as follows.
Step Procedure
1 If possible, the labeling system should be run empty.
2
Push the [AUTOMATIC OFF] –button at operator panel to stop automatic
labeling operation.
3 Push the [STOP] –button at labeler.
4
Remove all products.
5 Turn off the main switch.
6 Observe the notes „Putting the system out of service“ (s. page 45).
Putting the system out of service
When turning off the system for several hours, the label web
must be removed from the labeler to avoid failures at re-start.
The label material running around the deflection rollers is curved which can cause
problems with the operation mode. This characteristic of the labels as well as the retained
curvature depend on the material which can vary significantly between the different print
media. The ambient conditions such as high temperatures and humidity enhance this
effect.
Remove critical label material before long breaks and after end of work from
labeler!
Instruction
Please put the labeling system out of service as follows.
Step Procedure
1 Stop labeling operation (s. page 45).
2
Turn off labeling machine (s. page 43).
3
Disconnect the power supply.
4 Protect the labeling station if applicable from dust with a cotton or linen cloth.
5 If the labeling system should be stored and/or transported, please observe
the notes referring…

Transport (page 25)

Storage conditions (page 28)
6 Transport the labeling station like described in chapter „Transportation and
unpackaging“ to its storage location