Webasto Transit Vancouver Wagon, Manual

Page: 23 / 44

23
Ford Transit Vancouver
NOTE: The location of this hole is not critical,
but it must avoid the factory-equipped rear
HVAC module.
13. Drill a 2 in (51 mm) hole approximately 2.5 in (64
mm) from the side wall, and approximately 3.5 in
(89 mm) from the chassis outrigger. Protect the
cut edge against corrosion and chaffing and install
a grommit (57).
14. Using two #6 90º fittings (30) connect a high-
pressure hose (28) from condenser output port to
the input port on the filter/dryer.
15. Connect a #6 90º fitting (30) to the output on
the filter/dryer and route the hose (28) through
the hole drilled in the floor.