Webasto Transit Vancouver Wagon, Manual

Page: 32 / 44

32
Vancouver Ford Transit
NOTE: The wiring must be routed above
and behind the air bags.
NOTE:
Route the battery power and ground har-
nesses (59, 63) along the roof-line of the vehicle
to the circuit boards. Connect to the basic circuit
board using the BAT and -GND posts.
Due to vehicle variances some connectors
will be different than the one pictured.
24.Connect the controller harness (58) and route
it along the roof-line to the area above the
rear-view mirror.
Connect the pink wire to a 12V ignition-on
circuit at the open connector in the battery
compartment.
25.Use jumpers (60, 62), connect the +BATT and
-GND terminals on the basic board to the
same terminals on the extreme board.
Connect the jumper harness (61) from board-
to-board. Route the wiring for the condenser
fans (65), HP/LP switch (64), and A/C
compressor (66) from the electrical boards,
down the e-pillar and through the hole in the
floor.