Page 38 of 59
The Commands
available for serial port controlled paging using the
WaveWare Paging Protocol
include:
System
Identification
Paging
Message
Setup
Status
PAGING MESSAGE COMMAND
The Paging Message
command is formatted as follows:
Example 1:
<SOH>TBCC...C<STX>XXXX...XXX<ETX><EOT>
Example 2:
<SOH>T,B,CC...C,<STX>XXXX...XXX<ETX><EOT><CR><LF>
Note:
The commas, the
<CR>
character, and the
<LF>
character are optional in the
Paging Message
command. They
are used for appearance purposes to separate subparts of the command string and for formatting the echoed output while
troubleshooting the system.
<SOH>
(Hex code 01) is used to mark the start of a message. This character resets the paging system
and can be used to abort an incomplete paging command at any point prior to transmission.
T
Alphanumeric character representing the type of paging message to be transmitted
A =
Alphanumeric
N =
Numeric
1 =
One Beep (tone/vibe only pagers)
2 =
Two Beeps (all pager types)
3 =
Three Beeps (all pager types)
4 =
Four Beeps (tone/vibe only pagers)
B
Numeric character representing the data rate, in bits per second, at which the
paging message is to be transmitted
5 =
512 bps
1 =
1200 bps
2 =
2400 bps
Note:
This numeric character may have one or no leading commas separating it from the paging message type.
WaveWare Interface Specifications continued on next page…
